Schlumpf hubs: general discussion

[MuniOrBust]

A few pics, that might help. I added ‘danger_uni’ to my searching.

older

36er Bar options: Stoker stem vs Touring Bars

Here’s a photo of my geared KH26 with my handle setup for this particular uni. I like having both handles; I guess you could cut off one of the sides of the bar but it would expose the brake lever and not gain much IMO. Key to this setup is that I cut the “T” narrrower (to 120 mm width); otherwise in such a close and low position it would bump my knees. With that width it also makes it easier to grab the brake (closer to your fingers). [KH26.jpg]

non-geared

New Fusion Zero ultra low curvature unicycle saddle

Attached are a few photos of my current setup for all kinds of Muni except pure technical DH. It is incredibly comfortable. I feel like I could ride forever without chafing or front soreness. All the pressure is on the sit bones. Control is good, especially for technical XC where you are twisting a lot and pulling over roots. Saddle angle is set at 1 groove visible (2nd to highest angle). The “T” of the T-bar is cut to 120 mm width. The photos show a prototype T-bar handle with a curve th…

New Fusion Zero ultra low curvature unicycle saddle

Attached are photos of the T-bar mounted without the front handle, as close as it can get to the saddle. My guess is that this may become one of the most popular choices for muni and all-around use. Note that the the F Zero has the plastic handle inset 2.5 mm into the base (increases the height of ribs through the front part). That means that you need to stack about 3 mm of washers between the L bracket and the base, at each bolt. See the attached photo. [Tbar 12.jpg] [Tbar 6.jpg] [Tbar 1…