Attached are a few photos of my current setup for all kinds of Muni except pure technical DH.
It is incredibly comfortable. I feel like I could ride forever without chafing or front soreness. All the pressure is on the sit bones. Control is good, especially for technical XC where you are twisting a lot and pulling over roots. Saddle angle is set at 1 groove visible (2nd to highest angle). The “T” of the T-bar is cut to 120 mm width.
The photos show a prototype T-bar handle with a curve that’s not currently available.
However it’s possible to get close to the setup with the uncurved T-bar handle or (with the handle somewhat further out) the Shadow handle bar; I think there were photos/comments previously about that setup.
The front bumper with the hole is easiest to cut; alternatively the front handle could be removed and spacers / washers inserted under the L-brackets before bolting them to the saddle.
Kris
