Thanks so much for all the info for your new 36” Schumpf - and contacts for Roger. The build looks fantastic.
I’m about to build my wheel with the 125 Schlumpf and Dominator 2 rim. I could only get 367mm long spokes from unicycle.com Australia, and it seems that I need 360mm (359.57) Disc side and 362mm (361.95) non-disk side.
(Results calculated from unicycle.com spoke calculator.)
If Roger reads this, could I ask if those are the spoke lengths you used for that wheel build. Also interesting, that you used spoke washers, I might follow…what was the reasoning for using those.
With spoke lengths, I’m thinking of getting a thread cutting/rolling tool to add more thread length to my 367mm spokes and then cut to 360mm and 362mm (maybe cut 36 spokes to 360mm) I also have the option of getting a wheel builder to build the wheel or just cut and thread the spokes for me. I have a couple in mind, but any info from this forum would be much appreciated.
What threading tool was used for the 36” schlumpf? Cutting or rolling.