Thanks guys, never found my camera but figured out to get pics off my iPod. Who would have thought that gimmicky little camera would come in handy?
Here is the “wheel deal”
The join
and clearance on a KH36 frame
Ben: I sewed the two beads together really well and am mostly using glue to hold the casings together. The single line of stitching is mostly to hold everything in place while the glue was drying. I did all the stitching first, gooped up the seams real good (about 4cm overlap) and then installed and inflated the tire until the glue set.
The RR was the first tire I have encountered that no matter how careful I was I could not peel back the tread so it is just a simple join with a full casing/tread on top of a casing with tread removed on the bottom. Ideally I would peel the tread back and sandwich one casing with tread removed between the other casing and corresponding tread rubber.