3D printed brake support on KH T-Bar fixing (to ride without the handlebar)

[Yannick]

Hello everyone,
I am quite new to the forum.
I post pictures of a piece that I drew and printed in 3D.
If it can interest someone …
I am pretty new to unicycle. So it may seem bad to experienced or maybe it already exists …
This is a support to quickly remove the T-Bar KH handlebar and put the brake alone without having to dismount all the fixings (which is a bit tedious).
In fact I do not control the handlebars yet. Neither the brake :).
Mounting: KH Freeride saddle + KH T-Bar on unicycle Qaxle Qx Serie 36 inches with disc brake.
Yannick