View Single Post
Old 2018-07-05, 09:01 PM   #57
jtrops
Unicyclist
 
Join Date: May 2008
Location: Longmont, Colorado
Age: 51
Posts: 2,299
if you have a dremel tool, or a small hand held motor tool you can use a cutoff wheel to slot the inner race of the bearing. I would go slowly, and stop before you go through all of the way to protect the spindle. once you get a slot into the race you should be able use a cold chisel, or maybe even a straght screwdriver to break it open, and then it should be easy to pull off. If it is still difficult you may need to make a second slot.
__________________
"A properly ridden unicycle is like an object in orbit: constantly falling but never landing." -Diogenes
jtrops is offline   Reply With Quote
 
Page generated in 0.02937 seconds with 9 queries